Roland JUNO-Gi - Manual (Page 21)

21
Applying an Insert Eff ect
The JUNO-Gi’s digital recorder provides an eff ect processor that rivals dedicated units .
1. In the RECORDER screen, press the [6] (EFFECT) button .
The recorder’s eff ects (INSERT FX) screen will appear .
2. Press the cursor buttons to move cursor and use the VALUE dial to choose an insert eff ect number .
3. After you’ve made eff ect settings, press the [EXIT] button to return to the RECORDER screen .
Reference
For details on the insert eff ect, refer to page 109 in the Owner’s Manual .
Adjusting the Internal Input Level
1. Press the [AUDIO INPUT] button twice so it’s lit .
The AUDIO INPUT SELECT window will open .
2. Turn the VALUE dial to adjust the internal input level (the Input Level fi eld) .
Adjust the internal input level so that the level meter does not go all the way to the maximum even when the loudest volume occurs .
In some cases, applying an insert eff ect to the input sound may boost the internal digital level . If so, play the input sound and adjust the Input Level
setting so that the level meter in the screen does not reach the maximum (“CLIP” is shown when the level meter reaches the maximum position) .
3. Press the [6] (CLOSE) button to close the AUDIO INPUT SELECT window .
Recording
Selecting the recording track
1. Press the [ ] button to return to the beginning of the song .
2. Press the [●] (REC) button .
The [●] (REC) button will blink; you’re now in recording-standby mode .
In recording-standby mode, the TRACK [1/5] button will blink red .
3. Press the TRACK [3/7] button to select track 3 as the track for recording .
The selected track button will blink red .
Recording
4. Press the [ ] (PLAY) button .
The [●] (REC) button and [ ] (PLAY) button will light, and recording will begin .
5. Record your performance .
6. To stop recording, press the [■] (STOP) button .
The [●] (REC) button and [ ] (PLAY) button will both go out .
* You can’t play back sounds with a recording time of less than one second .
MEMO
Even when you’re not in recording-standby
mode, you can select the track to record
by holding down the [SHIFT] button and
pressing a TRACK [1/5]–[4/8] button .