Roland JUNO-Gi - Manual (Page 23)

23
Adjusting the equalizer settings for each track (EQ SETTING)
Parameter Value Explanation
On/Off OFF, ON Equalizer (EQ) switch for each track
Low
Low Gain
-12–+12 dB Amount of boost/cut for the low range
Low Freq 40 Hz–1 .6 kHz Center frequency of the low range
Mid
Mid Gain
-12–+12 dB Amount of boost/cut for the midrange
Mid Freq 20 Hz–10 kHz Center frequency of the midrange
Mid Q 0 .5–16
Width of the midrange
Higher values make the width narrower .
High
High Gain
-12–+12 dB Amount of boost/cut for the high range
High Freq 400 Hz–16 kHz Center frequency of the high range
Controlling the parameters of two tracks simultaneously (STEREO LINK)
For tracks 1 and 2 on which you recorded the piano in stereo, an “=” is shown between the parameters; editing the parameter value of one track
will cause the value of the other track to change simultaneously . This state is called “stereo link .” You can enable or disable stereo link as follows .
1. In the TRACK SETTING screen, move the cursor to the parameter for which you want to enable (or disable) stereo
link .
2. Press the [2] (ST LINK) button .
Reference
For details on stereo link, refer to page 89 in the Owner’s Manual .
Selecting the Reverb Type
1. In the RECORDER screen, press the [6] (EFFECT) button .
The recorder’s eff ects (INSERT FX) screen will appear .
2. Press the [2] (REVERB) button, and then use the VALUE dial to select the type of reverb .
Reference
For more about reverb, refer to page 117 in the Owner’s Manual .
Repeating the same phrase several times
If you want to repeat the same phrase several times, you can use the TRACK EDIT menu command Track Copy to copy the track data repeatedly .
Example: Copying the data twice to the same track
START
END
TO
Time
Reference
For details on the TRACK EDIT menu, refer to page 98 in the Owner’s Manual .