Raymarine S1000 - Manual (Page 11)

S1000 Autopilot Installation Guide 9
Installation procedures
1. Connecting the autopilot pump
O
Po rt Po rt
B
re c S d e e l
r i o v r e e s R w
Rese
v i r
r o Bl ee
w
S cr e
d
Po rt Po rt
Connecting the autopilot pump, sheet 1
D7345-1
Port
connector
Starboard
connector
Reservoir
connector
1. 2.
Secure the required hydraulic joints
(elbow or straight) into the autopilot
pump, as described under
Installing
tapered thread fittings.
CAUTION:
Do not use the transparent hose for connecting any part of the
steering system other than between the autopilot pump reservoir
and the lower connector on the helm pump.
Connect the hydraulic hoses to the
autopilot pump. Ensure the transparent
hose is connected to the reservoir
connector.
WARNING:
Do not allow hydraulic fluid to come into contact with your skin.
Wear the protective nitrile gloves provided when working with
hydraulic fluid.
WARNING:
A sudden release of pressure from a hydraulic system could result in
personal injury. Before disconnecting any part of a hydraulic
steering system, safely release any pressure in accordance with the
manufacturer’s instructions.
WARNING:
The autopilot pump is not suitable for use in the vicinity of
engines, fuel tanks or in any other area where fuel vapor is likely
to be present.
87040_5.book Page 9 Monday, April 30, 2007 5:58 PM