Chapter 2 installation and configuration, Installation, Requirements – RTS TBX - TriBus ADAM User Manual
Page 21: Installation and configuration
17
CHAPTER 2
Installation and Configuration
Installation
Requirements
•
10 Base-T or 100 Base TX Ethernet connection to the network
•
AZedit 3.6.1 or higher
•
MCII-e Master Controller 2.0.4 or higher
To install the Tribus into an ADAM frame, do the following:
1.
Firmly push the back card into slot 8, 9, or 10 in the ADAM frame.
NOTE:
Depending on the number of Tribus cards you are using determines the slot the card will occupy.
1 card = slot 8, 2 cards = slots 8 and 9, and 3 cards = slots 8, 9, 10.
2.
Using a screwdriver, secure the back card into the frame with the provided screws.
3.
Firmly push the front card into the front corresponding back card slot.
4.
Securely lock the front card in place with the top and bottom extractor handles.
FIGURE 36.
Tribus Backcard Slots