Rimage 110716-000 - Manual (Page 21)

Run Masker
When selected, the Rimage Raster Masker displays allowing you to adjust the mask (non-
printable area) settings for the selected media type ( Standard CD/DVD 120 mm only). This
works well when printing rectangle or square pictures on the disc and you do not want the
edges printed. If you print on the edges of a disc where there is not printable surface, the ink
will smear or run.
Standard Area Settings let you adjust the standard outer and inner diameter settings, etc.
Hub Settings let you select the Print On Hub feature and adjust the related outer and inner
diameter settings.
Parameter Unit lets you switch between a unit of measure of times 1.0 mm or times 0.1 mm.
Maintenance
The maintenance section allows you to select alignment functions, diagnostics, or update the flash.
Center Image – The Center Image function is only required if the printed image is not
centered on the label. Directions are found on the next page.
Align Cartridges – directions are found on page
11 .
Diagnostics – directions are found on page 25 .
Update Loader Flash – Rimage recommends using the Production Server to update the
autoloader flash firmware. Refer to page 25 .
Clean Cartridges – Cleans the ink jet nozzles when the jets are dried out. Refer to page 26 .
21