ROTEL RLC-1080 - Manual (Page 13)

13 English
Connected equipment reboots
or turns off when the RLC-1080
switches to battery power.
Possible Cause: Battery was disconnected
after unit was installed and powered on.
Solution: If the battery is disconnected a
warning appears in the VFD display. Remove
the front bezel by grasping the sides and pulling
straight back. Check the battery connection to
make sure that it is firmly pushed into its battery
connector socket.
Possible Cause: Unit is overloaded.
Solution: If too much equipment is plugged into
the RLC-1080 the amount of time the system can
be powered while running on battery power is
very short. Using the front display, you can see
how much of the UPS load capacity is used. See
the section of this manual titled System Load:
<XXXW; Load: <XXX%. Additionally, there is an
Overload LED on the front panel which will
light ‘red’ if the unit is overloaded. If the unit is
near overload or overloaded (>95%), the load
should be reduced by unplugging one or more
components.
Possible Cause: Battery charge level was
low at the time the RLC-1080 switched to bat-
tery power.
Solution: Allow the RLC-1080 to fully recharge,
by leaving the unit plugged in. It takes approxi-
mately 8 hours to recharge a discharged battery
to 90% capacity.
Possible Cause: If the above problem remains
unsolved....
Solution: Contact Rotel Technical Support at
800-370-3741.
Replace Battery LED is illuminated.
Possible Cause: Battery is nearing the end
of its useful life.
Solution: If it is more than two years from from
the date of purchase, a Replacement Battery Car-
tridge (part# RBC63) can be ordered from your au-
thorized Rotel dealer or Rotel Technical Support at
[email protected] or 800-370-3741.
Limited Warranty
Rotel warrants this product to be free from
defects in materials and workmanship for a
period of two years from the date of purchase.
Rotel’s obligation under this warranty is limited
to repairing or replacing, at its own sole op-
tion, any such defective products. To obtain
service under warranty contact your authorized
Rotel dealer or Rotel Technical Support at
800-370-3741.
If a product has to be returned for service you
must include the following:
• Prepaid transportation charges
• Brief description of the problem encoun-
tered
• Proof of date and place of purchase
This warranty does not apply to equipment that
has been damaged by accident, negligence, or
misapplication or has been altered or modified in
any way. This warranty applies only to the origi-
nal purchaser who must have properly registered
the product within 10 days of purchase.
EXCEPT AS PROVIDED HEREIN, ROTEL MAKES
NO WARRANTIES, EXPRESSED OR IMPLIED,
INCLUDING WARRANTIES OF MERCHANT-
ABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. Some states do not permit limitation
or exclusion of implied warranties; therefore,
the aforesaid limitation(s) or exclusion(s) may
not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT
WILL ROTEL BE LIABLE FOR DIRECT, INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES ARISING OUT OF THE USE OF THIS
PRODUCT, EVEN IF ADVISED OF THE POSSIBIL-
ITY OF SUCH DAMAGE. Specifically Rotel is not
liable for any costs, such as lost profits or revenue,
loss of equipment, loss of use of equipment, loss
of software, loss of data, costs of substitutes,
claims by third parties, or otherwise.