Rheem Warrior Series AP10414-9 - Manual (Page 17)

17
Replacement Parts.
For 20–52 gallon models with single or double elements.
TU RN OF F PO WE R BE FO RE SE RV ICIN G
140 130 120 110 100 90
T H E R M - O - D I S C
R E SE T R E SE T
140 130 120 110 100 90 T H E R M - O - D I S C
TU RN OF F PO WE R BE FO RE SE RV ICIN G
Instructions For Placing a Parts Order
Address parts orders to the distributor or
store where the heater was purchased.
All parts orders should include:
The model and serial number of the
water heater from the rating plate.
Specify voltage and wattage as
marked on the rating plate.
Part description (as noted below) and
number of parts desired.
CAUTION: For your safety DO NOT
attempt repair of electrical wiring,
thermostat(s), heating elements or other
operating controls. Refer repairs to qualified
service personnel.
Relief valve
Junction box cover
Anode rod
Hot outlet heat tube
(on side connect models
only)
Jacket access cover
*These parts are supplied only on
double element models
Jacket access cover
Thermostat bracket
Cavity insulation
Upper thermostat*
Plate cover
Relief valve
Hot outlet heat trap
or dip cup insert
(on top connect models only)
Top Connect Models
(see illustration below for other parts)
Dip tube gasket
(on top connect
models only)
Dip tube (on top connect models only)
Dip tube gasket
(on top connect models only)
Shroud
Drain valve
Cold inlet nipple
(on side connect models
only)
Anode rod
Junction box cover
Plate cover
Heating element gasket*
Upper thermostat protective cover*
Lower thermostat
Lower thermostat protective cover
Cavity insulation
Heating element*
Thermostat bracket*
Heating element gasket
Heating element
Some models may have
been supplied with
External heat traps
in lieu of Internal heat traps