Raymarine 465 - Manual (Page 38)

27 Operating Instructions
BOT
LOCK
The “Bottom Lock” Mode shows a “bottom-up” view. The
bottom is used as a reference, and all depths are
measured from the bottom up.
For more information, see the section on “Performance Modes” on page
49.
Turning the Power On and Off
Press the PWR button once to turn on the power. For a few seconds, the
Lamp/Contrast Menu will appear and the panel light will flash on and off.
The light will allow you to see in order to set up the display in the dark.
After the screen flashes three times, the unit will go to the display page
which was used last (unless this is the first time the unit is powered up).
The first time power is supplied to the unit, you will be asked to select the
language used by the displays. English is the default language. You may
also select any of six other languages. (You can change this setting at
any time using the System Setup Menu.)
To turn the power off, press and hold the PWR button for more than 3
seconds.
Setup Memory
When you first turn on the power, the unit will be prepared to operate
using a number of preset values. These “default” values are stored in the
unit at the factory. (The default values are listed in Section 4.)
This unit has a memory for some of the settings—range, sensitivity,
zoom, and frequency. (We will explain these in a moment.) When you
turn off the power, any changes you make to these settings will be saved.
You can return all of the settings to the factory default values, and reset
the trip log to zero. To reset the unit, confirm that the unit is off. Press and
hold the CLEAR button, then press the PWR button for a moment. After the
unit powers up, release the CLEAR button.