Radio Shack PRO-83 - Manual (Page 41)

41 Beyond the Basics
Storing Frequencies Found During
Chain Search into Channel Memory
You can store frequencies you find in chain search
mode or chain search hold mode.
X Press FUNC + PGM in chain search mode or
chain search hold mode. The lowest blank
channel and bank appear.
Y Press E to store the frequency into the blank
channel. To select another channel, press FUNC
+
or before you press E. To enter the
frequency, press FUNC. disappears. Then
press E. You can also press 0-9 to select the bank.
If you try to save a frequency that is already stored,
the scanner sounds an error tone and displays the
channel that was duplicated. If you entered the
frequency by mistake, press ./CLR. To enter the
frequency anyway, press E to accept.
The scanner sets itself to program mode after you
store a frequency.
Program Band Select Mode
You can use this mode to define the search range
used during a chain search in each search bank. To
set the scanner to program band select mode, press
FUNC + B.SLCT. SEARCH appears. Then select a
search bank.
F