Radio Shack PRO-83 - Manual (Page 53)

53 Beyond the Basics
[
To set up the program, click on Tools, select
Configuration, and select PRO-83 (if necessary).
\
Turn on the scanner. The scanner automatically
goes into the wired programming mode. PGM
and WirEd appear. Then send the data from the
PC.
Data frame numbers being received appear.
]
When the scanner has successfully received all
data, End appears. If the scanner received an
error while receiving data, End, d-Err, and its
frame number appear. If the scanner received a
communication error while receiving data, C-Err
indicates the packet number where the error
occurred. If the scanner received a checksum
error while receiving data, S-Err indicates the
packet number where the error occurred. If the
scanner received a length field error while
receiving data, L-Err indicates the packet number
where the error occurred.
Using the Display/Key Backlight
To turn on the display/key light for easy viewing at
night, press
. The display lights for 15 seconds.
To turn off the light sooner, press again.