Radio Shack Cordless Room Monitor - Manual (Page 10)

10 Preparation
9. Place the receiver into the charging slot on the charger.
The POWER/CHARGE indicator on the charger lights.
After the battery is charged, you can use the receiver while it is
still in the charger. If you carry the receiver around with you,
place it back in the charger when you are through using it so it
can charge.
If the POWER indicator does not light recharge the battery.
Notes:
• If the POWER/CHARGE indicator does not light when you
place the receiver into the charger, be sure the AC adapter
is correctly and securely connected. Also, check the charg-
ing contacts on the receiver and the charger. If the contacts
are dirty or tarnished, clean them with a pencil eraser.
• The supplied battery should last for several years. If the
battery will not hold a charge for more than 2 hours after an
overnight charge, replace the battery. You can order a
replacement from your local RadioShack store.
Important: The EPA certified RBRC ® Battery Re-
cycling Seal on the nickel-cadmium (Ni-Cd) bat-
tery indicates RadioShack is voluntarily
participating in an industry program to collect and
recycle these batteries at the end of their useful
life, when taken out of service in the United States or Canada.
The RBRC program provides a convenient alternative to placing
used Ni-Cd batteries into the trash or the municipal waste
stream, which may be illegal in your area. Please call 1-800-
THE-SHACK (1-800-843-7422) for information on Ni-Cd battery
recycling and disposal bans/restrictions in your area.
43-489rc.fm Page 10 Tuesday, October 3, 2000 10:12 AM