Raymarine 300 - Manual (Page 53)

Chapter 3: Operation 3-25
The Route Building Table shows available Waypoints in the left hand
column (in alphanumeric order). The right hand column contains the
waypoints in the New Route. The number to the left of the waypoint
name in the New Route column indicates its order in the route. The lower
part of the table shows position, bearing and range of the highlighted
waypoint.
3. Use the trackpad left/right to alternate between the two columns; the
highlighted title indicates the selected column. Use the trackpad
up/down to scroll through the lists.
4. Select a waypoint from the Waypoint List, go to the New Route col-
umn and select a position in the list.
5. Press the INSERT WAYPOINT soft key to place the waypoint below the
selected position in the Route.
6. To remove a waypoint from the New Route column, highlight the
waypoint and press the REMOVE WAYPOINT soft key.
Notes: (1)A waypoint cannot be used more than once in a route; those al-
ready used are grayed out.
(2)The INSERT WAYPOINT or REMOVE WAYPOINT action adds/re-
moves the highlighted waypoint to/from the Route column, re-
gardless of which column is selected.
3. When all waypoints have been entered, press the ACCEPT ROUTE soft
key (or ENTER) to complete the route.
Note: The completed route is stored in the display unit and will be re-dis-
played if you turn the unit off then on again. However, on an integrated
system it is possible for a current route from another unit to overwrite this
route; it is therefore recommended that you Save the route, as described
in Saving the Current Route on page 3-27.
➤
To make a new route by placing waypoints using the cursor:
Note: You can pan the display and change the scale whilst placing way-
points.
1. Use the DISPLAY key to select Plotter mode.
2. If necessary, move the cursor to the area in which you wish to make
the route and select a suitable scale.
3. Press the ROUTE soft key; the route soft keys are displayed as shown
in Figure 3-30.
Figure 3-30: Route Soft Keys
MAKE
ROUTE
EDIT
ROUTE
CLEAR
ROUTE
MORE¬
D4913-1