Raritan Engineering SeaEra Toilets - Manual (Page 8)

8
90° Rotation of Toilet Bowl
Toilet bowl can be rotated 90° on the base, for
installing in confined locations.
NOTE: SeaEra Models with Integral Pump:
Replace existing hose from the intake pump to the
toilet bowl with a longer hose.
1. Determine which direction bowl is to be
mounted.
2. Remove hose at back of toilet (Sea Water
Model with Integral Pumps ONLY).
3. Remove four vinyl caps at the base of toilet
bowl.
4. Remove four nuts and shoulder washers.
5. Carefully remove toilet bowl from base.
6. Rotate toilet bowl to desired position.
7. Replace four shoulder washers, nuts and vinyl
caps.
NOTE: Tighten nuts carefully and evenly. Do
Not over tighten.
Mounting Push Button Switch
• Mount Push Button Switch in an accessible
location.
• Make certain wires can be routed to Push
Button Switch.
• Wire terminals must have clearance when
installed.
1. Drill 5/8" (16mm) hole.
2. Attach wires to Push Button Switch terminals
(see wiring section).
3. Install Push Button Switch through back of
mounting surface.
4. Install waterproof nut on Push Button Switch.
5. Secure in place with inner nut.
Install the Warning Label (L322) where it can
be easily seen.
INST
ALLA
TION
1/4" Minimum clearance from terminals to any object
Inner Nut