RuggedCom RUGGEDBACKBONE RX1501 - Manual (Page 27)

RuggedBackbone™ RX1501
Installation Guide
Chapter 3
Installation
Serial Console Port 21
Figure 45: Critical Alarm Relay Connector
Section 3.4
Serial Console Port
The serial console port on the front panel provides access to the boot-time control and configuration menu
interface, and a console interface to the ROX operating system.
The serial ports implement RS232 DCE on a female DB9 connector. Serial settings are: 57600 bps, 8 bits, No
parity, 1 stop bit. See the illustration and table below for pin configuration and assignment.
Figure 46: DB9 Serial Console Port
Table 2: DB9 Serial Console Pinout
DB9 Pin Signal Function
1 NC
2 TX
3 RX
4 NC
5 GND
6 NC
7 NC
8 NC
9 NC
Section 3.5
WAN Ports: RJ45
The RX1501 supports T1/E1 WAN ports, to interface to standard T1 or E1 telecommunication infrastructure.
Carefully note the orientation of the RJ45 receptacle when inserting or removing cabling. See the illustration and
table below for pin configuration and assignment.