Roland SC-545EX - Manual (Page 83)

81 Chapter 4: A Wide Variety of Operations
4-8 Recording the Amount of Remaining Media
Displaying the Amount of Remaining Media on the Screen
You can display how much of the media in use is left.
Once you set the amount of media remaining, the amount remaining is displayed at the top menu until it reaches zero. If
you cancel the setup such as by removing the media or raising the loading lever, the amount remaining at that time flashes
on the screen.
* The remaining amount that is displayed is only an estimate, and its accuracy is not assured.
1 Press the [MENU] key, and press the [ ] key
to make the following screen appear on the dis-
play.
2 Press the [ ] key to make the following screen
appear on the display.
3 Press the [ ] key to make the following screen
appear on the display.
4 Press the [ ] key to make the following screen
appear on the display.
Use the [ ] and [ ] keys to set the amount of
media remaining, then press the [ENTER] key.
5 Press the [MENU] key, then the [ ] key to go
back to the original menu screen.
The amount of media remaining that you set is
displayed.
The amount of media remaining is not updated automatically when you change the media. Redo the setting whenever you
change the media.
Note, however, that when sheet media is loaded (that is, when [SETUP SHEET] is set to [PIECE]), the amount of media
remaining is set automatically.
MENU
SHEET REMAIN
SHEET REMAIN
PRINT MEMO
SHEET REMAIN
SET LENGTH
SET LENGTH
0.0 m 20.0 m
W1234mm L20.0m SETUP SHEET
ROLL L20.0m
or
You can also make this menu appear automatically when you change the media. In addition, you can print the amount of media
remaining for later reference. For more information, go to "6-2 Description of Menus" and refer to "SHEET REMAIN."