Rheem Electric Domestic Water Heater - Manual (Page 15)

INSTALLATION
THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING
WATER HEATER LOCATION
This water heater is suitable for either outdoor or indoor installation (a model
with a supply cord and plug is suitable for indoor installation only). Whether
located outdoor or indoor, the water heater should be installed close to the
most frequently used outlet and its position chosen with safety and service in
mind.
Clearance must be allowed for
servicing of the water heater. The
water heater must be accessible
without the use of a ladder or scaffold.
Make sure the temperature pressure
relief valve lever is accessible and the
front cover, thermostat, heating unit
and if fitted, the side cover and
temperature limiting valve can be
removed for service.
You must be able to read the
information on the rating plate. If
possible leave headroom of one water
heater length so the anode can be
inspected or replaced. Remember you
may have to take the entire water
heater out later for servicing.
The installation must comply with the requirements of AS/NZS 3500.4,
AS/NZS 3000 and all local codes and regulatory authority requirements. In New
Zealand, the installation must conform with the New Zealand Building Code.
It is recommended the water heater be installed at ground or floor level and
must stand vertically upright. Remember all local authorities have regulations
about putting water heaters into roof spaces.
15