Warning, Safety, To turn off the water heater – Rheem Electric Domestic Water Heater User Manual

Page 6: About your water heater

Advertising
background image

ABOUT YOUR WATER HEATER

WARNING

This water heater is only intended to be operated by persons who have the
experience or the knowledge and the capabilities to do so. This water heater is
not intended to be operated by persons with reduced physical, sensory or
mental capabilities i.e. the infirm, or by children. Children should be supervised
to ensure they do not interfere with the water heater.

This water heater uses 240 V AC power for the electrically operated
components. The removal of the front cover(s) will expose 240 V wiring. It must
only be removed by an authorised or qualified person.

A water heater fitted with a power supply cord and plug, must be plugged into a
weatherproof electrical outlet if installed outdoors. Take care not to touch the
power plug with wet hands.

SAFETY
This water heater is supplied with a thermostat, an over-temperature cut-out,
and a combination temperature pressure relief valve. In addition, a RheemPlus
water heater has a temperature limiting valve. These devices must not be
tampered with or removed. The water heater must not be operated unless each
of these devices is fitted and is in working order.

If the power supply cord, plug or electrical conduit to the water heater is
damaged, it must be replaced by an authorised person in order to avoid a
hazard. The power supply cord and plug must be replaced with a genuine
replacement part available from Rheem. Phone your nearest Rheem Service
Department or Accredited Service Agent to arrange for an inspection.

The warranty can become void if relief valves or other safety devices are
tampered with or if the installation is not in accordance with these
instructions.

TO TURN OFF THE WATER HEATER
If you plan to be away from home for only a few nights, we suggest you leave
the water heater switched on.

If it is necessary to turn off the water heater:

Switch off the electrical supply at the isolating switch to the water heater.

Unplug the power supply cord from the power outlet (power supply cord
model only).

Close the cold water isolation valve at the inlet to the water heater.

6

Advertising