Radio Shack Pro-97 1,000 - Manual (Page 54)

54
Beyond the Basics
scanner to stop on one channel.
When your scanner stops on a conventional frequency that is
confi gured for CTCSS or DCS, it checks for a match between
the transmitted and stored codes match, the scanner stops
on the transmission and allows the audio to pass to the
speaker. If the codes do not match, the scanner resumes
scan operation. If the special “search” code is in use, the
scanner will instantly display any detected CTCSS code if
programmed for CTCSS mode, or DCS code if programmed
for DCS code. You can store the detected code into the
channel memory by pressing ENT while the code is displayed.
For more information about your scanner’s receive modes,
including CTCSS and DCS, see “Understanding Your
Scanner’s Modes”. For more information on programming
memory channels for CTCSS or DCS operation, see “CTCSS
and DCS”.
deleting frequencies from channels
1. Press MAN.
2. Use the number keys to enter the channel with the
frequency you want to delete.
3. Press MAN again.
4. Press PGM to enter the program mode. M changes to P.
5. Press FUNC.
6. Press CL. The frequency number changes and 0.0000
appears.
deleting all frequencies in a channel bank
1. Press PGM.