Radio Shack Pro-97 1,000 - Manual (Page 71)

71
Beyond the Basics
programming Motorola trunking systems (800 MHz)
Follow these steps to program 800 MHz band Motorola
trunking.
On the 800 MHz trunking band, you can select a base
frequency (normal or offset).
On the 900 MHz trunking band, you do not need to set the
base frequency (base, offset, step).
1. Press PGM then TRUNK to enter the ID program mode.
2. Press FUNC then e or d to select the desired bank.
3. Press MODE and select Motorola trunking mode.
4. Press FUNC then 3. Use Up/Down keys to set 800MHz Motorola ch
plan NORMAL appears.
5. Press e or d to select NORMAL or SPLINTER and press ENT.
• If you are uncertain about the base frequency, use the
default setting. The default setting is normal.
• If you cannot receive with the normal setting, change to
OFFset. The base frequency in normal is 851.0125 MHz.
The base frequency in OFFset is 851.0000 MHz.
programming fl eet maps
You must set the fl eet map if you want to receive a
Motorola Type I system. Fleet maps are included along with
other information about Motorola Type I systems at
www.
trunkscanner.com .
Follow these steps to program a fl eet map.
1. Press PGM then TRUNK.
2. For each bank you want to program, repeatedly press
FUNC. Then e or d to select the bank.
Notes Notes