Ryobi AIRgrip Procross Laser level self leveling ELL0006 - Manual (Page 10)

10
OPERATION
ROUgH SURfACE ADAPTOR
See Figure 7.
By using the rough surface adaptor, you can use the AIRgrip
feature to position the unit on many non-smooth surfaces,
including brick and painted cinder block.
NOTE: The AIRgrip feature cannot be used with stucco or
unpainted cinder block.

Place the adaptor over the AIRgrip base.
 Place the unit against the desired surface and press
slightly to engage the seal.
 Continue to hold the unit against the surface while press-
ing the on/off button.
 Slowly release the unit when you hear a change in motor
sound.
CAUTION:
Before releasing the unit, make sure the unit is securely
adhered to the surface.
USINg THE MULTI-fUNCTION BASE
See Figures 8 - 9.
Hook-and-loop strap and push pin methods are available
when the multi-function base is installed. To install, snap the
base over the AIRgrip vacuum seal.
HOOK-AND-LOOP STRAP: The strap can be used to attach
the laser level to irregularly shaped objects such as pipes,
boards, or metal grates.

Attach the strap to the multi-function base by threading it
through the loops. The looped (or fuzzy) side of the strap
should face the base.
 Position the laser level against the surface where you
want it mounted.
 Wrap the strap around the object being mounted (pipe,
board, etc.) and pass the end of the strap through the
retaining loop. Pull to tighten.
 Place the hooked end of the strap against the looped (or
fuzzy) side of the strap and press together to secure.
NOTE: To use the hook-and-loop strap to hang the unit from
overhead, use the loops on top of the laser level housing.
PUSH PINS: Push pins allow the laser level to be mounted
to stucco and permeable surfaces.

Place the laser level on the surface where you want it
mounted.
 Align push pin with angled hole located on one side of
laser level base and push in to secure.
 In the angled hole on the other side of laser level base,
secure the second push pin.
Fig. 9
Fig. 8
Fig. 7