Ryobi AIRgrip Procross Laser level self leveling ELL0006 - Manual (Page 12)

1
MODEL NO.
ELL0006
WAVE LENGTH: 630-670 NM
MAX. POWER OUTPUT < 5MW
CLASS IIIA LASER PRODUCT
LASER RADIATION-
AVOID DIRECT
EYE EXPOSURE
Complies with 21
CFR parts 1040.10
and 1040.11
Rayonnement laser
- éviter le contact oculaire
direct Lire les instructions
du manuel.
PELIGRO
Radiación láser
- Evite la exposición directa
de los ojos. Lea las
instrucciones en el manual.
EVITE La Radiación De
Laser de la EXPOSICIÓN
Emitida De Esta
Abertura
DANGER
ÉVITEZ Le Rayonnement
De Laser d'EXPOSITION
Émis De Cette
Ouverture
Laser radia
tion emitted from these apertu res. AVOID EXPOSURE-
DANGER
MAINTENANCE
WARNINg:
To avoid serious personal injury, always remove the bat-
teries from the product when cleaning or performing any
maintenance.
gENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNINg:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
ALWAYS BE AWARE of the location where
the laser light is emitted when using the laser
level attachment. ALWAYS MAKE SURE that
any bystanders in the vicinity of use are made
aware of the dangers of looking directly into
the laser beam.
 Store the unit indoors.
 When not in use, the vacuum base and attachments
should be kept in the protective case.
 Keep the unit free of dust and liquids. Use a damp cloth
and mild soap to clean the outside casing. Avoid using
solvents when cleaning plastic parts. Most plastics are
susceptible to damage from various types of commercial
solvents and may be damaged by their use.
 To clean the laser lens, if needed, use ONLY a soft cloth
or cotton swab moistened with glass cleaner.
 Check the batteries regularly to avoid deterioration.
Remove the batteries from both the vacuum base and
the laser if you will not be using the unit for an extended
time.
 Do not disassemble the laser level. This could cause
exposure to hazardous laser radiation.
 Do not attempt to change any part of the laser lens.