Ruckus Wireless MM2211 - Manual (Page 17)

8000013, July 2006 MM2211 Wireless Broadband Gateway User’s Guide 17
Accessing the Web Interface
After logging in, you will see the main information page. On the information page, there are two panes. The
pane on the left shows major information or configuration points. Each major information or configuration
area has a number of sub-menus. Clicking on the relevant menu will bring the relevant page onto the screen.
The system monitors the activities on the Web user interface. If you do not use the Web interface for more
than five minutes, the system will time out, and you will be logged out automatically. You need to re-log in
to access the interface.
6. In the Configuration->Wireless menu, you may change the default wireless network Name (SSID) for this
device to match the SSID of the AP you intend to connect to.
7. Refer to the information provided under the Help button before attempting to change any other default
settings in this screen.
8. The initial configuration is now complete. Click Reboot/Reset to make the change take effect.
!
CAUTION:—Make sure to write down the new IP address, username, password and SSID. If you change the
MM2211 Gateway’s default IP address to one outside the current address range of your PC, you will not be
able to connect to the device after reboot until you reset your computer’s IP address to be within the same
network as the MM2211 Gateway. See
Table 4, “Wireless Network Settings Worksheet,” on page 20 and
Table 5, “MM2211 Gateway Default and User Settings Worksheet,” on page 21 for more information.
You should now be able to find the default SSID of your MM2211 Gateway over your wireless connection:
Accessing the Web Interface
!
CAUTION:—Any configuration changes will be lost unless you use the Update button. It is recommended
that after each configuration screen you modify, you click the Update button.