Ruckus Wireless MM2211 - Manual (Page 20)

20 MM2211 Wireless Broadband Gateway User’s Guide 8000013, July 2006
Wireless Settings Worksheet
Wireless Settings Worksheet
Before you modify any wireless settings on the MM2211 Gateway, print Table 4— “Wireless Network
Settings Worksheet” and record the following information about your wireless network. Your ISP or network
administrator may provide you with this information. The wireless information recorded in this worksheet
should be used to configure the MM2211 Gateway’s wireless settings.
Table 4—Wireless Network Settings Worksheet
Item Description and Your Network Setting
MM2211 Gateway SSID The SSID identifies the remote AP. Make sure to specify the SSID of the Mesh
Networks Router, or the SSID as defined by the Metro ISP provider.Once you
obtain the SSID from the Metro ISP provider, this is the value you must enter as the
MM2211 Gateway SSID. You can use up to 32 alphanumeric characters. The SSID
is case sensitive.
Security If using WEP, circle the method used: [Open System] [Shared Key] [Auto}
Circle the type of Shared key: 64-bit 128 bit
Passphrase method
• If using 64-bit WEP: use 10 hex digits (any combination of 0-9 or a-f) or 5
ascii characters
• If using 128-bit WEP, use 26 hex digits or 13 ascii characters
The WEP key values are not case-sensitive.
Key 1 ______________________________________________
Key 2 ______________________________________________
Key 3 ______________________________________________
Key 4 ______________________________________________
If using WPA-PSK, write down the passphrase. The WPA-PSK passphrase is
case-sensitive.
WPA Passphrase: ________________________________