RightWay GPS Navigator RW 200 - Manual (Page 8)

8
Locking Lever
Dash Disc
MOUNTING YOUR RW 200
Your RW 200 GPS Navigator can be easily secured to either the windshield or the dash for optimal
viewing while driving. The mounting system consists of the following pieces:

Adjustable arm with suction cup

Navigator cradle

Dash disk with adhesive backing
ATTACHING THE MOUNT
1. Select a location for the mount on the windshield or dashboard that does not
obstruct the driver‟s view or interfere with the operation of the vehicle.
2. Clean and dry this area to remove any grease and dirt.
If mounting the RW Navigator on the dashboard, remove the
protective backing from the dash disc, exposing the adhesive.
Adhere the disc to the dashboard in the desired location.
The adhesive is permanent.
3. Place the suction cup on the desired location on the windshield or
dash disc; push the locking lever towards the base of the mount.
The mount should stick to the surface.
If your mount does not stick, make sure the area is clean and
dry, then try again.
4. Align the tabs on the holder with the slots on the Navigator cradle.
Slide together until you feel a firm click.
5. Adjust the holder to the best viewing angle by:
a. Loosening the adjustor dials
b. Moving the corresponding part to the desired position
c. Tightening the adjustor dials.
6. Align the grooves on the bottom of your unit with the tabs on the bottom of the
navigator cradle; gently push the unit into the cradle until the unit clicks into
place.
7. To remove the RW Navigator from the mount, gently push back the tab on the
top of the cradle until you hear a click releasing the unit.