Radio Shack ET-1124 - Manual (Page 11)

11
Notes:
• The redial memory holds up to 32
digits, so you can redial long-dis-
tance as well as local numbers.
• The redial memory also holds pause
entries. See “Entering a Pause” on
Page 13.
USING MUTE
To talk to someone in the room without
the person on the other end of the
phone line hearing your conversation,
press
MUTE . The TALK/BATT indicator
flashes. Press MUTE again or TALK to
resume your phone conversation.
USING FLASH
FLASH performs the electronic equiva-
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press
FLASH to answer an incoming call
without disconnecting the current call.
Press
FLASH again to return to the first
call.
Note: If you do not have any special
phone services, pressing
FLASH might
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Be sure DIAL MODE is set to P
(pulse).
2. Dial the service’s main number.
3. When the service answers, press
TONE . Any additional numbers you
dial are sent as tone signals.
4. After you complete the call, return
the handset to the base or press
TALK . The phone automatically
resets to the pulse mode.
PAGING
To page the person who has the hand-
set (or to locate the handset when the
phone is not in use), press
PAGE/FIND
on the base for less than 2 seconds. The
handset beeps for about 5 seconds. To
sound the beep for 1 minute, press
PAGE/FIND more than 2 seconds. Or,
hold down PAGE/FIND for over 1 minute
to make the handset beep until you re-
lease
PAGE/FIND .