Radio Shack ET-1124 - Manual (Page 6)

6
3. Route the adapter and modular
cords through the grooves on the
bottom of the base.
4. Plug the modular cord’s other end
into the wall plate jack, then align
the base’s keyhole slots with the
wall plate studs and slide the base
downward to secure it.
5. Plug the adapter into a standard AC
outlet.
6. Press and lift out the handset
holder, rotate it 180°, then snap it
back into place so it holds the hand-
set.
7. Lift the base’s antenna to an upright
position.
Note: To mount the phone directly on a
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the base.
Follow the steps under “On a Wall Plate
or Wall” on Page 5, then apply these ad-
ditional instructions for placement on a
wall.
1. Drill two holes 3 15 /
16
inches (100 mm)
apart. Then thread
a screw into each
hole, letting the
heads extend about
5 /
16
inch (8 mm)
from the wall.
2. Plug one end of the supplied long
modular cord into the TEL LINE jack
on the back of the base.
3. Align the base’s keyhole slots with
the mounting screws and slide the
base down to secure it.
Handset
Holder
3 15 / 16
Inch