Rosewill RCW-605. - Manual (Page 8)


User Manual USB TO IDE 2.5”+3.5”+SATA Cable RCW605
Notification
. RCW-605 can support totally two ATA / ATAPI / SATA devices working together in one time.
You can connect one 2.5" or one 3.5" ATA/ATAPI and one SATA devices together to your PC.
(Only one 2.5" or 3.5" ATA device can work in one time)
2. Please take off your ATA / ATAPI / SATA device from RCW-605 only after you turn off the
power to avoid any damage.
3. If you plug RCW-605 and HD to PC, PC might freeze during the beginning of booting. In this
case, you may unplug RCW-605 at the start of booting and re-plug it after PC enters windows.
4. If PC can’t detect RCW-605 and HD in windows, please try the following. Unplug RCW-605
and try to reboot the PC. Re-plug it after system enters windows. If all above still can’t help, it
might be caused by the incompatibility between HD, system or controller chipset.
Please contact us for more support.
Trouble shooting
i. Q: I completed the installation by following the menu but MS Windows can’t detect any
hard drive.
A: The reason of the problems could be:
. Hard drive has not completed the format or F-disk process.
* Solution: Format or F-disk your hard drive.
2. The hard drive failed.
* Solution: Replace a workable hard drive.
3. Bad USB connection.
*Solution: Unplug the USB connection and re-connect the USB again.
4. Check LED light on the adapter. If the red LED light on RCW-605 is not on after
connected with PC, this adapter is not working correctly.
*Solution: Please contact our RMA department for replacement.