Rosewill RCW-605. User Manual
Page 9
8
User Manual
USB TO IDE 2.5”+3.5”+SATA Cable RCW605
ii. Q: After I installed RCW-605 to the hard drive, my hard drive will not run.
A: Four pin power connector is directional. If you plug in the four pin power connector in
reverse, your hard drive might be damaged.
*Solution: Please make sure the direction of 4 pin power connector is correct before you
plug it to your hard drive. The shape of the male 4 pin connector must fit the female
connector of your hard drive as pictures shown below.
iii. Q: Fail or slow system boot up when RCW-605 was connected with PC.
A: This issue is caused by the hardware confliction of the system scanning during boot up.
*Solution:Please disconnect RCW-605 from your PC before system boot up.
Connect it to PC after the Windows complete boot up.
Thank you for purchasing a quality Rosewill Product.
Please register your product at : www.rosewill.com/
for complete warranty information and future support for your product.
If you have any question while using our products, please feel free to contact us at
[email protected] .