ROWENTA TO 810 VENUS User Manual

Page 10

Advertising
background image

10

SAFETY INSTRUCTIONS:

To prevent any accidents:

This toaster complies with the safety rules and conditions in effect, and with the following directives.

Electromagnetic Compatibility Directive 89/336/CEE modified by Directives 92/31/CEE and 93/68/CEE.

Low Voltage Directive 73/23/CEE modified by Directive 93/68CEE.

Given the many standards in effect, if this toaster is used in a country other than the country where it was purchased,
have it checked by an approved service centre.

Check that the electricity supply voltage corresponds to the voltage indicated on the appliance (ac current only).

Check that the electricity installation is sufficient to supply the power required by this appliance.

Always plug the toaster into an earthed socket.

Do not let the cord hang and keep out of reach of children. Do not leave the cord in contact with the warm parts of
the appliance.

Do not disconnect the appliance by pulling on the cord.

Use extension cords which are in good condition, with an earthed connection, and with a minimum rating of 10A.

In order to avoid electric shock, do not immerse the cord, the plug or the toaster in water or any other liquid.

Do not use metal ustensils in the toasting mechanism, which could cause short circuits or electric shock
(spoon,knife...).

WARNING: THIS APPLIANCE MUST BE EARTHED. FOR UK ONLY

Important: the wires in this lead are coloured in accordance with the following codes:

Green and Yellow: Earth
Blue: Neutral
Brown: Live

Connect the Green/Yellow wire to the terminal in the plug marked “E” (or by the
earth symbol) or coloured Green or coloured Green and Yellow. Connect the Brown
wire to the terminal in the plug marked “L” or coloured Red. Connect the Blue wire
to the terminal in the plug marked “N” or coloured Black. A 13 amp fuse should be
fitted when the appliance is connected to a BS 1363 plug. Seek professional advice
if you are unsure of the correct procedure for the above.

VOLTAGE

This appliance is designed to run on 230 - 240 volts only. Check that the mains supply corresponds to that shown on
the rating plate of the appliance. If the appliance is to be used in any country other than that of purchase, it should
be checked by an approved Service Dealer. Standards can vary from country to country.

ABOUT YOUR FACTORY FITTED PLUG

FOR UK ONLY
(supplied with certain models only)
The cord is already fitted with a plug incorporating a 13 amp fuse. If the plug does not fit your socket outlet, see next
paragraph.
Should you need to replace the fuse in the plug supplied, a 13 amp approved BS 1362 fuse must be used.
The fuse cover is an important part of the plug. Please ensure that it is always refitted. If you lose this cover please
do not use the plug.
If the plug supplied does not fit your socket outlet, it should be removed from the mains lead and disposed of safely.
The flexible cord insulation should be stripped back as appropriate and a suitable alternative plug fitted. The replace-
ment plug must be equipped with a 13 amp fuse.
Important: If the electrical cord of this appliance is damaged, it must only be replaced by an authorised Service Dea-
ler. The safety of this appliance complies with the technical regulations and standards in force.

2749-3304044 exe VENUS FAAH 25/09/02 15:25 Page 10

Advertising