Ryobi P420 - Manual (Page 12)

12
OPERATION
TO INSTALL BATTERY PACK
See Figure 4.

Place the battery pack on the tool.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is se cured on the
tool before beginning operation.
TO REMOVE BATTERY PACK
See Figure 4.

Depress the latches on the side of battery pack.
 Remove the battery pack from the tool.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
LOCK-OFF BUTTON
See Figure 5.
The lock-off button is located on the handle above the switch
trigger. You must depress the lock-off button in order to pull
the switch trigger. The lock resets each time the trigger is
released.
SWITCH TRIGGER
See Figure 5.
To turn the grinder
ON, depress and hold lock-off button,
then depress the switch trigger. To turn it OFF, release the
switch trigger.
Fig. 5
Fig. 4
BATTERY PACK
LOCK-OFF
BUTTON
SWITCH
TRIGGER