Ryobi P420 - Manual (Page 14)

14
POSITIONING THE GUARD
See Figures 7 - 10.
The guard on the grinder should be correctly installed
depending on which side the handle is mounted.
Never
use the grinder without the guard correctly in place.
WARNING:
Never place the guard so that it is in front of the grinder
as shown in figure 7. This could result in serious injury
because sparks and loose particles thrown from the
grinding wheel would be directed toward the operator.
Always place the guard in the correct location as
shown.
To adjust the guard:
� Remove battery from the grinder.

� Unlock the guard clasp by pulling the clasp out, away
from the grinder.
 � Rotate the guard to its correct position as shown.
NOTE: Be sure the raised ridge on the guard is seated
in the groove on the bearing cap. Never use the grinder
without the guard in place and properly adjusted.
ROTATING FOOT
See Figure 11.
The foot of the grinder can be rotated up to 270° to the left
for easier access to hard to reach areas. Stops are located
at 90°, 180°, and 270°.
Fig. 9
SIDE HANDLE ON LEFT SIDE OF GRINDER
TOOLLESS
GUARD
OPERATION
Fig. 8
TOOLLESS
GUARD
CLASP
Fig. 7