RCA STAV3860 - Manual (Page 17)

17
DISPLAYS AND CONTROLS
FRONT PANEL
OSR
DOLBY SURROUND
P R O • L O G I C
3
3
3
2
2 3 2
2
~ ! ^ % = $ @ #
1 2 3 4 5 6 7 8 9 0 -
1 POWER button
Switches the receiver between on and standby.
2 STANDBY indicator
Lights when the receiver is in standby mode (note
that the receiver consumes a small amount of
power (1W) in standby mode).
3 STATION 2 3 (–/+), FREQUENCY 2 3
(–/+), TUNING SELECT buttons
STATION
2 3 (–/+)
Selects station memories when using the tuner.
FREQUENCY
2 3 (–/+)
Selects the frequency when using the tuner.
TUNING SELECT
Switches between station memory and frequency
select modes (see pages 23–25).
4 CLASS button
Switches between the three banks (classes) of
station memories (see page 25).
5 MEMORY button
Press to memorize a station for recall using the
STATION
2 3 buttons (see page 24).
6 MPX MODE button
lf the TUNED or STEREO indicators don't light
when tuning to an FM station because the signal
is weak, press the MPX button to switch the
receiver into mono reception mode. This should
improve the sound quality and allow you to enjoy
the broadcast (see page 23).
7 Display (see page 18)
8 Remote sensor
Receives the signals from the remote control.
9 DSP MODE button
Use to switch between the various DSP modes
available (
HALL, JAZZ, DANCE, THEATER 1,
THEATER 2 ) and DSP off. Use to create different
surround sound effects from any stereo source
(see page 22).
0 DOLBY PRO LOGIC button
Use to switch between the various Pro Logic
modes (PRO LOGIC, PRO LOGIC with
THEATER 1, PRO LOGIC with THEATER 2) and
Pro Logic off (see page 20).
- VOLUME
Use to set the overall listening volume.
= PHONES jack
Use to connect headphones but this does not
switch the speakers off.
~ SPEAKERS ON/OFF button
Use to switch the speaker system on or off.
! FL DIMMER button
Use this button to make the fluorescent display
(FL) dimmer or brighter. There are three
brightness settings as well as an off setting.
@ BASS 2 3 (–/+) buttons
Use to increase/decrease bass (within a range of
–6dB to 6dB in 2dB steps). It cannot be used
when S.BASS is on.
# TREBLE 2 3 (–/+) buttons
Use to increase/decrease treble (within a range of
–6dB to 6dB in 2dB steps).
$ Function buttons
Use to select a source for playback or recording.
% S.BASS button
Use to switch on and off the bass boost. Use for a
more powerful bass sound. Negates use of BASS
buttons.
^ DIRECT button
Use to switch DIRECT playback on or off. This
mode bypasses the tone controls and channel
levels for the most accurate reproduction of a
program source.