Raymarine Radar Scanner - Manual (Page 34)

26 Pathfinder Radar Scanners
ing on the thickness of the cable: use the position that matches the
profile of the cable.
CAUTION:
It is essential that the drain tube is fitted and that the nut on the
watertight gland is adequately tightened. If this is not done, water
could become trapped in the scanner and cause irreparable
damage.
13. Tighten the securing nut (1) again to ensure a waterproof seal.
14. If you have a 4D scanner, replace the inner cover over the connec-
tors.
15. Untie the cord from the scanner cover, and coil it up in the
base of the scanner unit so that it cannot foul the rotating
antenna.
16. Replace the scanner cover, aligning the mark on the cover with
the mark on the scanner base above the cable gland, and tighten
the 4 or 7 captive screws. Do not over-tighten these screws.
154_4.book Page 26 Wednesday, October 25, 2000 3:02 PM