Raymarine Radar Scanner - Manual (Page 40)

32 Pathfinder Radar Scanners
Re-connect to the plug. When correctly fitted the white wire (co-
axial) will be at the outer edge of the unit.
6. Connect the red and black power cores. Connect the red cable
leads to the terminal sockets marked “+”, and the black cable
leads to the terminal socket marked “-”, with one lead in each
socket. The terminal clamps are operated using a screwdriver as
shown in the inset diagram.
CAUTION:
Do not earth the cable screen to the scanner. The radar system is
earthed via the display unit.
7. Using the tie-wrap fitting on the pedestal lid, secure the cable.
8. Check the gasket in the pedestal lid is correctly seated.
Close the pedestal lid, ensuring that the cable does not become
trapped. Tighten the four self-retaining bolts.
CAUTION:
Do not grease the gasket in the pedestal lid.
Grey
Purple
Blue
Green
Yellow
Orange
Coaxial Screen
(Black)
Coaxial Inner
(White)
Signal connector
Power connector
D4576-2
154_4.book Page 32 Wednesday, October 25, 2000 3:02 PM