Raymarine autopilot control unit - Manual (Page 49)

32 ST7000 Plus Autopilot Control Unit Owner’s Handbook
Watch Alarm
WATCH
The Watch alarm is activated in Watch mode when the timer reaches
4 minutes. It is not available from Standby mode.
If you wish to set the Watch mode, the WATCH screen must be
configured as one of the Data Pages (see User Setup in Chapter 4).
To set and control the Watch alarm:
1. Select Auto, Track or Wind mode.
2. Press the disp key until the WATCH Data Page is displayed.
• The Watch timer starts counting.
• When the timer reaches 3 minutes, the text on the display starts
flashing to indicate the last minute of Watch alarm.
• When the timer reaches 4 minutes, the audible Watch alarm
activates.
3. Press auto at any time to silence the alarm and reset the timer to
4 minutes. (Pressing any other key resets the timer and performs
the key’s normal function).
4. To clear Watch mode, press disp to display a different page, or
press standby.
Note: You cannot engage Auto mode from the Watch mode – pressing
auto merely resets the Watch timer.
Route Completed
ROUTE alternating with COMPLETED
Occurs when you have reached the last waypoint.
To cancel the alarm, select either Standby, Auto or Wind mode.
AutoRelease
AUTO alternating with RELEASE
Occurs on stern drive vessels if you manually take over steering and
the autopilot relinquishes control.
The alarm cancels automatically after 10 seconds.
118ch03.p65 07/01/99, 12:42 32