Raymarine autopilot control unit - Manual (Page 70)

Chapter 4: Customising the System 53
the standard instruments and the ST7000 Plus into group setup
mode. When this occurs, one standard instrument is selected with
a flashing cursor, and the ST7000 Plus screen text will alternate
between
INST REM and DSP SETUP.
4. At the ST7000 Plus, use the up arrow or down arrow key to select
an instrument to be the first in the group.
5. Use the ST7000 Plus to allocate a group letter and sequence
number to the selected instrument. To do this, use the
track key to
toggle between group letter and sequence number, and the set crs
key to set the identifying character. When the instrument has been
properly identified it should display its group letter and sequence
number, e.g.
A2.
Note: All standard instruments are selectable while in group setup
mode.
6. Press either the up arrow or down arrow key to select another
instrument and repeat the procedure in step 5.
7. Repeat the procedures in steps 5. and 6. until all instruments in the
group have been identified.
Note: If you have more than eight ST60 or ST80 instruments, a second
group, operated by another remote keypad, must be created. The
identification code for additional keypads and display heads would be
for example,
B1, B2 etc.
8. Use the arrow keys to select one of the ST60 or ST80 instruments
in the group to which you want to allocate the ST7000 Plus as a
keypad.
9. Hold down the up and down arrow keys together for 1 second.
The ST7000 Plus screen text will alternate between
INST REM and
KPD SETUP, and each of the instruments in the selected group will
display prompt messages similar to the following.
118ch04.p65 07/01/99, 12:43 53