RCA CC9360 - Manual (Page 41)

Recording
Chapter 3 39
Cautions
• Never operate the video light closer than 1 foot to people or other
objects.
• The video light becomes very hot. Do not touch it during use or right
after use. Serious injury may result.
• Do not place the camcorder in a carrying case right after using the
light.
• Never operate the video light close to flammable or explosive
material.
• Consult your nearest RCA authorized service center to replace the
video light.
• The video light and bulb need to cool for approximately 30 minutes
after use before the bulb assembly is replaced.
BLAN K SEA RCH
FOCUS +
+
BAT. RELEASE
P LA
Y
O
FF
Power switch
Lock
button
MENU dial Time Code Display
During recording, a time code is captured on the
tape. This code confirms the location of the recorded
scene on the tape during playback.
If recording starts from a blank portion of the tape,
the time code begins counting from 00:00:00
(minutes: seconds: frame number). If recording starts
from the end of a previously recorded scene, the
time code continues from the last time code number.
Note: The time code is automatically set to
00:00:00 when a tape is ejected.
1. Press in the Lock button while setting the Power
switch to
M (manual record). (The POWER
indicator comes on.)
2. Press in the MENU dial. (The Main Menu
appears.)
3. Rotate the MENU dial to highlight DISPLAY.
Press in the MENU dial to select it. (The Display
Menu appears.)
4. Rotate the MENU dial to highlight TIME CODE.
Press in the MENU dial to select it. (The Time
Code Menu appears.)
5. Rotate the MENU dial to highlight the desired
setting. Press in the MENU dial to select it.
6. Press in the MENU dial twice to exit.