RIDGID OF45150 - Manual (Page 4)

The A-C motor used on this tool has the
following specifications. It is wired at the
factory for operation on 110V-120V AC,
60 Hz service.
Wired for 120V
Rated HP 1 1/2
Voltage 110-120
Amperes 13
Hertz (Cycles) 60
Phase Single
RPM 3450
Rotation of Shaft Clockwise
Motor Specifications and
Electrical Requirements
7
Safety Instructions (continued)
6
Find and read all warning labels found on
the air compressor shown below
Warning Labels
Power Supply and Motor Specifications
To reduce the risk of electrical
hazards, fire hazards or damage
to the tool, use proper circuit
protection. Your tool is wired at
the factory for operation using
the voltage shown. Connect
tool to a power line with the
appropriate voltage and a 15-
amp branch circuit. Use a 15-
amp time delay type fuse or cir-
cuit breaker. To reduce the risk
of shock or fire, if power cord is
worn or cut, or damaged in any
way, have it replaced immedi-
ately.
! WARNING
General Electrical Connections
To reduce the risk of electrocu-
tion:
1. Use only identical replace-
ment parts when servicing.
Servicing should be per-
formed by a qualified techni-
cian.
2. Do not use in rain or where
floor is wet. This too is
intended for indoor residen-
tial use only.
! DANGER
Do not permit fingers to touch
the terminals of plug when
installing or removing the plug
to or from the outlet.
! WARNING
DK724100AV 10003
Figure 1