RIDGID R2400 - Manual (Page 17)

17
OPERATION
Fig. 14
USING EDGE GUIDE
See Figure 14.
���Use the edge guide to trim or cut a straight edge.
n
Unplug the laminate trimmer.
n Thread guide bars into the base and tighten with a flat
head screwdriver.
n Slide the edge guide onto the guide bars.
n Remove the two thumb screws from the bearing guide
assembly and install into the edge guide.
n Measure the proper distance to offset the cutter, or if trim-
ming, position the cutter at the edge of the workpiece.
n Tighten the two thumb screws to secure the edge
guide.
n Move the trimmer along the workpiece keeping the edge
guide in constant contact with edge of the workpiece.
EDGE GUIDE
THUMB SCREWS