Raymarine ST60 - Manual (Page 22)

12 ST60 Rudder Angle Indicator Instrument Owner’s Handbook
2. Using both thumbs, gently press an upper corner of the instrument from the
bezel, then remove the bezel from the instrument. Retain the rubber keypad
which is released when the bezel is removed.
3. Place the instrument face upwards on a flat surface and place the rubber key-
pad (7) in position around the display window (i.e. so that each key outline is
located over its associated key on the instrument).
4. Snap the low-profile bezel (8) in position over the instrument, so that the rub-
ber keys are correctly located in the holes on the bezel.
CAUTION:
It is essential that only screws of the correct size are used to
secure the instrument to the bezel. Failure to observe this caution
could result in damage to both the instrument and the bezel.
5. Using the four, self-tapping screws (9) provided, secure the instrument and
bezel together. Fit the screws from the rear of the instrument and tighten
them sufficiently to secure the instrument and bezel together. DO NOT OVER-
TIGHTEN.
D4358-2
Fitting the low profile bezel
7 8 9