Raymarine ST60 - Manual (Page 23)

Chapter 3: Installation 13
Flush mounting procedure
Flush mount your instrument (see the
Flush mounting illustration) as follows:
1. Assemble the ST60 instrument and low-profile bezel as described under Fit-
ting the low-profile bezel .
2. Ensure that:
• The panel on which you intend to mount the instrument is between
0.12 in (3 mm) and 0.78 in (20 mm) thickness.
• The selected location is clean, smooth and flat.
• There is sufficient space behind the location to accommodate the rear of
the instrument and connectors.
3. Apply the flush mount template (supplied at the rear of this handbook) to the
selected location and mark out the aperture into which the assembled instru-
ment and bezel will sit.
4. Cut out the aperture (3) for the assembled instrument and bezel and remove
the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then stick the
gasket into position on the rear of the bezel.
6. Screw the two fixing studs (1) into the threaded sockets on the rear of the
instrument.
Flush mounting
D4332-3
4
1 3 1 5 6 5