Rangemaster Toledo 90 Gas - Manual (Page 26)

26
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the floor covering is firmly fixed, or
removed to prevent it being disturbed when moving the
cooker around. You will need the levelling tool.
From the back tilt the cooker forward and remove the
rear half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base.
LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut
as shown below.
Make 10 complete (360º) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There
are two adjusting nuts, one for each roller, at both the
front bottom corners of the cooker. Open the grill door
and the Tall oven door. Grip under the facia panel and
lift the front of the cooker.
Carefully push the cooker backwards close to its final
position leaving just enough space to get behind it.
Take care not to damage the power cable.
Do not use the door handles or control knobs to
manoeuvre the cooker. Use the hotplate and griddle
bowl areas. Remove the pack base tray.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level
the cooker. To adjust the height of the rear of the
cooker use the levelling tool supplied to turn the
adjusting nuts at the front bottom corners of the cooker.
To set the front feet turn the bases to raise or lower.