Ricoh GX8 - Manual (Page 121)

119
Ch
angi
n
g
Cam
e
ra
Set
tings
Changing Power-Save Mode Settings
(POWERSAVE)
You can reduce the power consumption of the LCD Monitor and extend the life
of your batteries.
The display on the LCD Monitor will turn off. Press the Q (Quick Review)
button or the M button to turn the LCD Monitor Display on, and then
press them again to turn the display off.
Press the ADJ. button to turn the LCD Monitor on for setting. After the end of
setting, the display returns to off.
You cannot turn the LCD Monitor Display on/off by pressing the T (Self-timer)
or N (Macro) button.
At the time of purchase, Power-Save Mode is set to [OFF].
To change the Power-Save Mode, follow the steps below.
1.
Turn the Mode Dial to 1.
2.
Press the " button to select
[POWER SAVE].
3.
Press #$ to select the desired
setting.
This setting will be used until you change
it.
Note
• If the power is turned on or the mode dial is turned in Power-Save mode, a warning
appears for about two seconds to indicate Power-Save mode.
• Pressing the F (Flash) button allows you to turn the LCD Monitor Display on, and then change
the flash setting. Press the shutter button or OK button to turn the LCD Monitor Display off.
Caution
If you have activated Power-Save mode, power consumption will be reduced, but there are
the following limitations.
• Processing time may be slower.
• It works only in Shooting Mode. It does not work in Playback Mode.
Possible Settings
OFF (Power-Save Mode Inactivated) *Initial setting at purchase
ON (Activate Power-Save Mode)