Raymarine DSM300 - Manual (Page 15)

Chapter 2: Getting Started 15
2.4 Selecting Repeater Mode
Depth data that is to be shared over the hsb 2 network is sourced from the device
that has been designated as the master sonar unit. Only a DSM300 or an hsb 2
PLUS Series fishfinder display can be a master unit. For the DSM300 master to
repeat its sonar image data to a display unit, the display must be designated as
the REPEATER.
When using the DSM300 with a PLUS radar or chartplotter display, this is not an
issue—the DSM300 is automatically set as the master and the display unit the
repeater. However, the DSM300 can also repeat its image data on a fishfinder
display. In this case, both units are capable of collecting sonar data. You must tell
the display it is to be a repeater for the DSM300 and not a master unit on its own.
If your DSM300 is repeating its sonar data over a PLUS Series radar or chartplotter
display, the proper settings are made automatically. You need do nothing else.
However, if your repeater display is a PLUS Series fishfinder, you must tell the unit
to be a repeater.
➤
To set the fishfinder display to be the sonar repeater:
1. Press the DISPLAY key until SONAR mode is selected, as described in the
previous section.
2. Press the MENU key.
The Menu soft keys appear.
3. Press the SONAR SET UP soft key.
The Sonar Set Up menu appears.
4. Press the trackpad until the SONAR HSB MODE parameter is highlighted
(selected).
5. Press the REPEATER soft key.
6. Press ENTER.
The display unit is now designated as the Repeater.
Details on setting up your DSM300 and display are given in Chapter 3.
DISPLAY
MENU
SONAR
SET UP¬