Raymarine DSM300 - Manual (Page 69)

Chapter 5: Sonar Mode Operation 69
The top line status bar shows the condition of the alarms:
• indicates an alarm is enabled. The speaker symbol is unfilled until an alarm
is triggered and silenced, then the symbol is shown solid.
• S indicates the shallow alarm is enabled; a pop-up window indicates when
the alarm is triggered.
• D indicates the deep alarm is enabled; a pop-up window indicates when the
alarm is triggered.
• indicates the fish alarm is enabled.
External Alarms
All SeaTalk system alarms (except autopilot, shallow, and deep) alarms are
received and displayed in Sonar mode. You can silence these alarms by pressing
any key. No other action is taken except to silence the alarm.
➤
To set an alarm:
1. Press the ALARMS key. The alarms soft keys are displayed.
2. For the shallow or deep alarms, press the SHALLOW ALARM or DEEP ALARM
soft key then use the up or down soft keys to change the alarm limit.
Press the up arrow (right) soft key to select deeper water; press the down
arrow (left) soft key to select shallower water.
3. If desired, press the ALARM OFF ON soft key to toggle the alarm on or off. If
you turn the shallow or deep alarm off, its value is retained and will be used
when you turn the alarm on again.
4. Press ENTER or CLEAR to save the changes and clear the list.
➤
To silence an alarm and clear the alarm message, press any key.
DEEP
ALARM
SHALLOW
ALARM
FISH
ALARM
OFF ON
D5031-1
ALARMS