Rimage EverestTM Printer - Manual (Page 26)

Rimage Everest Printer
20 110632_L
Changing the print ribbon
Before changing the Everest print ribbon, allow time for the new ribbon to become acclimated to
the environment. Allow more time for greater temperature and/or humidity differences.
-
Important! Ribbons must be stored at a temperature between 50°– 90°F (10–32°C). Avoid
moisture and direct sunlight. Do not reuse ribbons.
Before you begin:
Power off the printer.
1. Remove the print ribbon.
a. Press the two cover latches to
release the side cover.
b. Lower the side cover.
c. Turn latch 1 counter-clockwise.
d. Remove the print ribbon
carrier.
e. Remove the print ribbon from
the carrier.
2. Discard the used print ribbon.
#
Tip: Perform cleaning
procedures while the print
ribbon is removed. Refer to
‘Cleaning the Everest printer’ on
page 24.
Cover latches
Side cover
Print ribbon carrier Latch 1