Rimage EverestTM Printer - Manual (Page 36)

Rimage Everest Printer
30 110632_L
n
p
re to observe this guideline could result in loss or damage to the equipment,
before using the equipment.
n
o not use any voltage other than 110VAC or 220VAC. This could result
n
nician, or sent in for repair. Do not service the printer with the power cord
n be opened by hand. Do not insert your fingers.
n
n
p
p
rmal smell is detected. This may result in
ell, immediately disconnect the cable
p
gned for an office environment.
p
Caution! If the side cover is opened while power is supplied, the printer will stop. Never reach into the
printer while it is operating. Do not attempt to bypass the door interlock.
Technical support and product updates
Support for the Rimage Everest printer is available through your authorized reseller.
-
Important: Register your Rimage Everest printer so we can notify you of upgrades as they
become available.
Safety information
This manual and the indications on the product allow proper and safe operation. The indication marks below
help protect you and other persons from injury, and equipment from damage.
Warning! According to ANSI (American National Standards Institute) standards, a warning is used to
indicate situations that could result in bodily injury to personnel operating or maintaining the equipment.
Caution: Indicates that failu
product, software, or data.
To ensure safety, please read the precautions in the User Guide and familiarize yourself with their meaning
Safety Precautions
Warning! This printer has a voltage slide switch on the back of the unit. Before use, check that it is set
to the correct voltage. Please d
in a fire and an electric shock.
Warning! Do not disassemble or use tools on the printer. All service procedures should be performed
by an authorized field tech
plugged in the AC outlet.
n
Warning! The front bezel of the printer ca
n
Warning! Do not touch the heater roller.
Warning! The interior of the printer contains sharp edges.
Warning! Keep out of reach of children.
Caution! Any equipment that has AC line voltage, or low DC voltages, such as switches, power
supplies, fuses, fans, non-stepper motors, must be replaced with Rimage–approved components to
maintain the safety approval issued by UL.
Caution! This printer has no power switch. Power is disconnected completely by unplugging the cable.
Rimage recommends installing the printer in a position that allows immediate disconnection of the
power cable. Always hold the plug when disconnecting the cable from the outlet.
p
Caution! Do not use the printer if it is overheating, or an abno
a fire and an electric shock. In case of heating or abnormal sm
from the outlet. Contact your dealer for repairs.
Caution! This product is desi
p
Caution! Allow sufficient free space for opening the printer drawer. Do not touch the printer drawer
while it is moving.