Connecting the air tubing – ResMed Sullivan Comfort User Manual
Page 10
SULLIVAN Comfort Operating Manual
10
Connect the air tubing to the flow generator and mask
IMPORTANT:
Make sure the power cord and plug are in good condition
and the equipment is not damaged.
Only use the same type of mask and air tubing as
originally supplied with your flow generator. A different
type of mask or tubing may alter the pressure you actually
receive, thus reducing the effectiveness of your treatment.
Air tubing
connector
Air outlet
Air tubing
Connecting the air tubing
1
The air tubing should already be fitted at one end with the air tubing connector
which inserts into the flow generator. If not, press the barbed end of the
connector into the air tubing as shown below. Make sure it is firmly attached.
2
Press the air tubing connector firmly into the air outlet on the flow
generator.
3
Fit the other end of the air tubing to the swivelling mask elbow of the mask
frame by sliding on firmly.
Note: If you are using an axial swivel connector (supplied with the Modular Mask
Frame or available separately) connect this also. Refer to the User Instructions
supplied with the axial swivel.
Swivelling
mask elbow