ResMed Sullivan Comfort - Manual (Page 8)

SULLIVAN Comfort Operating Manual –––––––––––––––––––––––––––––––––––––––––––––– 8
4 Fit the headgear to the mask frame as shown below.
• Thread the headgear straps
through the slots in the mask
frame – the lower straps
should also pass through the
slots on the cushion.
Note: If using the ResCap™,
position the straps so that the
sewn on “ResCap” label will
be at the back of your head
(lower center), facing
outwards.
Thread the straps in the
direction of the arrows as
shown.
Fit headgear to mask frame
Setting up the flow generator
1 Plug the power cord into the main power inlet at the rear of the flow
generator. Make sure the main power switch on the unit is off (O). Insert the
other end of the power cord into a power outlet.
* At the air inlet an air filter cleans the air that you breathe through
the mask. The air filter strips need to be replaced periodically, see
section 9, Cleaning and Maintenance, for details.
Plug in power cord at rear of flow generator
Power cord
Main power switch
Main power inlet
Air inlet (with filter*)