Raymarine A60 - Manual (Page 21)

Chapter 3: Installing the GPS Antenna 21
.
Surface Mounting
1. Use the template supplied in this handbook to mark the two 6 mm (0.25 in)
mounting holes.
2. OPTION A:
If the cable is going to pass through the mounting surface drill a 19 mm (0.75
in) center hole.
OPTION B:
If the cable is to exit from the side of the receiver above the mounting sur-
face, remove the two plastic tabs (1) obstructing the cable channel. If you do
not remove these tabs before using the cable channel, you could damage the
cable.
3. Screw the two mounting studs (2) into the underside of the receiver.
4. Stick the supplied gasket (3) to the mounting surface, ensuring that the holes
on the gasket correspond with the drilled holes.
5. Pass the cable down through the center hole (Option A) or route it through the
cable exit channel (Option B).
6. Carefully position the receiver so the mounting studs pass through the holes
in the mounting surface.
7. Secure the receiver to the surface using the two thumb nuts (4).
D8689-1
A
B
87081.book Page 21 Wednesday, December 20, 2006 2:43 PM